Installation Guide

4. DOWN Control Button:

7. Fahrenheit/Celsius Button:

REMOTE:

This button displays F (Fahrenheit) or C (Celsius) depending on how the

temperature mode is set. When the garage heater is turned on, the

Fahrenheit (F) temperature will be displayed.

GARAGE HEATER :

To switch from Fahrenheit to Celsius, or vise-versa, when the garage

heater is ON, hold HEATER CONTROL button for 5 seconds. Unless

power to the unit has been interrupted, the garage heater will remember

the last temperature mode setting will start at that setting,

horizontally if it has been installed with 2 lag bolts.

2. To tilt the unit vertically, loosen the bracket screws (see Figure 5 on page 6).

ADJUSTING AIR FLOW DIRECTION

1. To turn the unit when it has been installed with a single lag bolt (as shown in

gure 4a), simply turn the entire heater as needed. The unit cannot be turned

OPERATING INSTRUCTIONS

This button is used to decrease temperature or timer settiing. It adjusts the

temperature range between 10°C--35°C(50°F--95°F) in 2°F (/1°C) increments.

5. UP Control Button:

This button is increasing temperature or timer setting. It adjusts the

temperature range between 10°C--35°C (50°F--95°F) in 2°F (/1°C)

increments.

6. Timer Button:

This button controls the Timer ON/OFF and 8 settings from 1hour to 8

hours. When the Timer is first turned on, it will come on at the shortest time

setting (1hour). Each time the Timer button is pressed, the time increases

by 1 hour, up to the longest setting (8 hours). Once the set time expires, all

garage heaters functions will be automatically turn off.