Full Product Manual

CHECKING FOR LEAKS

After all connections are made, check all connections and ttings on the LP gas tank valve, gas hose

and regulator for leaks with a water and soap solution.

To prevent re or explosion while testing for a leak:

• Always perform leak test prior to lighting the heater.

• Do not smoke while testing for a leak.

• Always perform leak tests outdoors in a well-ventilated area.

• Do not use any source of ame while testing for leaks.

• Do not use the heater until any and all leaks are corrected.

• If you are unable to correct a leak, disconnect the propane supply and call a gas appliance service

dealer.

PERFORM LEAK TEST

• Prepare leak test solution by 50/50 ratio of liquid dish

soap and water. Total solution required is approximately

2 - 3 ounces (70 - 90 ml). Put leak test solution in a spray bottle.

• Ensure all control knobs are in the OFF position.

• Connect the gas hose to the gas supply.

• Open the LP gas tank valve.

• Spray leak test solution on all gas carrying connections

and ttings. Presence of bubbles at areas of applied test

solution indicates a gas leak. If leaks are detected or you

smell or hear gas, shut off the gas supply valve immediate-

ly (See Fig. 21) and repair or replace the defective part.

Do not use the heater until all leaks are corrected.

Fig. 21 - Equipment Shut-off Valve

INSTALLATION

WARNING

ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO

PREVENT FIRE, DAMAGE AND/OR INJURY.

NEVER Bring a Rellable Propane Cylinder Indoors. A Fire or Explosion can Occur Causing Prop-

erty Damage, Serious Injury or Death.

CAUTION

Only use the regulator and hose assembly provided! If a replacement is necessary, please call

our customer service center. Do not use replacement parts that are not intended for this heater.

Inspect the hose before each use of the heater. If it is evident there is excessive abrasion or wear,

or the hose is cut, it must be replaced prior to the heater being put into operation. The replacement

hose assembly shall be that specied by the manufacturer.

This Heater may be Used in a Recreational Enclosure or Temporary Construction Work Enclosure

with a Remote Rellable Propane Cylinder ONLY when the Cylinder is Located Outdoors and the

Heater is Used with Hose Kit No. KR-106-01