Use and Care Manual

8. LONG TERM STORAGE OF YOUR HEATER
• Unscrew fuel cap.
• Remove Kerosene from the tank by using an approved siphon pump.
• Rinse and swirl the kerosene inside the fuel tank by using a small amount of kerosene.
• Make sure the tank is completely empty.
Never leave kerosene in the tank over a long period time because using old kerosene can damage the heater.
9. MAINTENANCE
• Be sure that the storage area is free of dust and corrosive vapors. Repack the original shipping material.
keep the User's Manual in an easily accessible place.
6
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Store heater in a dry, well-ventilated area
Screw
Back Cover
Display PCB
wire
Operating Switch
wire
A) BACK COVER REMOVAL
Figure 4. Back Cover Removal
1) Remove 4 Screws along circumference of the Back Cover.
2) Disconnect Operating Switch Wire and Display PCB
wire from PCB Board.
3) Remove Back Cover.
B) FUEL TANK
Flush every 200 hours of operation or as needed
(See above,8.Long term storage of your heater)
WARNING!! : NEVER SERVICE HEATER WHILE IT IS PLUGGED IN OR
WHILE HOT!
USE ORIGINAL EQUIPMENT REPLACEMENT PARTS.
Use of third party or other alternate components
will void warranty and may cause unsafe operating
conditions.
TO RESTART THE HEATER
1.Wait 10 seconds after cooling cycle has completed.
2. Turn the Operating Switch to "ON" position.
3. Be sure to follow all starting procedure precautions.
CAUTION : Do not disconnect the power source or unplug the power cord until the cooling cycle has
been completed!
CAUTION : DO NOT operate heater without heat shield assembled to the heater.
Temperature of the floor is hot while in operation. Use the heater without heater shield,
will cause deformation or discoloration of the floor.
CAUTION : NEVER use an accessory thermostat with this heater.
Accessory thermostat will bypass the cooling cycle after the heater is shuts off
and damage the heater.