Instructions / Assembly

10. TIRE INFLATION
WARNING: Tires must be properly inflated before
riding. Never exceed the maximum pressure (PSI) that is listed on
the side of the tire.
WARNING: Be sure to check that the edge (beads) of
both tires are evenly seated the entire way around on both sides of
the tire. Failure to do so may result in the tire coming off of the rim,
the tube popping (see Figure 43), and a loss of control of the
bicycle, causing injury or even death.
WARNING: Using a service station air hose without a
pressure gauge may result in over-inflating of the tire and popping
of the tube. This could also cause irreparable damage to the tube
and tire.
Use a hand pump, foot pump, or floor pump to properly
inflate the tires (see Figure 44). The maximum inflation (PSI)
is shown on each tire sidewall (see Figure 42). If your pump
does not have a built in gauge, use a separate pressure
gauge to ensure the tires are inflated to the correct pressure
(see Figure 45).
Incorrectly seated Properly seated
30
C
Figure 42
Figure 43
Figure 44 Figure 45