User manual

Chapter 4: Web Configuration
31
Address and Subnet Mask to connect to your
router if they are not included in the range
that DHCP server accepts.
Secondary IP Address:
Type in the second IP address that you got
from your ISP for your LAN connection.
Subnet Mask:
Type in the subnet mask that you got from
your ISP for your LAN connection.
Enable DHCP server on the LAN:
Check this item if DHCP service is needed
on the LAN. The router will assign IP
address, gateway address for each of your
PCs.
Start IP Address:
Type in the start point IP address.
End IP Address:
Type in the end point IP address.
Leased Time:
Type in the duration for the time. The default
is 1day.
On the Configure LAN side Settings web page, the IP
address and subnet mask will be shown on it. You can
modify them if needed. Click Next for next page.
You can check it at this time. If you find
something is incorrect, click Back to change
the settings. If everything is OK, click
Finish to accept these settings. And the
following page will appear.
Now, the system will reboot to activate the
new settings that you have done in this
section.
Please wait for 2 minutes for restarting the
router.