DX Switchbox Installation Manual

DX Switchbox (DX-ARC-SWB) – Installation Manual
9
7.2 Maintenance
1. All vehicle components should be regularly checked for loose, damaged or corroded
connectors, terminals, or cabling. All cables should be restrained to protect them
from damage. Damaged components should be replaced.
2. All switchable functions on the Dynamic electronics system should be regularly
tested to ensure they function correctly.
3. All Dynamic electronic components should be kept free of dust, dirt and liquids. If
necessary, wipe with a cloth dampened with warm water or alcohol. Do not use
solvents or abrasive cleaners.
4. There are no user-serviceable parts in any Dynamic electronic component. Do not
attempt to open any case, or undertake any repairs, or warranty claims will be
affected.
5. Where any doubt exists, consult your nearest service center or agent.
Warning:
If any component is damaged in any way, or if internal damage may have
occurred (for example by being dropped), have it checked by qualified
personnel before operating.
7.3 Warranty
All equipment supplied by Dynamic Controls is warranted by the company to be
free from faulty materials or workmanship. If any defect is found within the warranty
period, the company will repair the equipment, or at its discretion, replace the
equipment without charge for materials and labour.
This Warranty is subject to the provisions that the equipment:
• has been correctly installed.
• has been thoroughly checked upon completion of installation, and all programmable
options correctly adjusted for safe operation prior to use.
• has been used solely in accordance with this manual.
• has been used solely for the driving of electrically powered wheelchairs in
accordance with the wheelchair manufacturer's recommendations.
• has been properly connected to a suitable power supply in accordance with this
manual.
• has not been subjected to misuse or accident, or been modified or repaired by any
personnel other than those authorized by Dynamic Controls.