Use and Care Manual

- 17 -

1. Remove terminal block cover plate located on the right end of the appliance. Keep screws

for reassembly.

2. Install a wire strain relief bushing into the cover plate.

3. Terminate type NM-B wire to the terminal block, ensure connections are secure, and tighten

the strain relief. Use 3/32 slotted head screwdriver, or equivalent, to depress the spring-

loaded terminals for the conductors.

4. Replace terminal block cover plate and retaining screws.

2.7 FIREPLACE REPAIR GUIDES

For full detailed instructions and step-by-step guides on how to

repair and service the fireplace, including repair and replacement of

parts such as LED lights, motor, heater, etc, please visit our support

website at:

support.dynastyfireplaces.com