Use and Care Manual
© 2023 Dynasty Fireplaces | V 1.0.0
- 4 -
SAFETY INFORMATION
•
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK---DO NOT USE THIS
HEATER WITH ANY SOLID-STATE SPEED CONTROL DEVICES.
• This product is
not intended
to be a
primary heat source.
It is for
supplemental heat only.
•
INDOOR use only!
NEVER
use this heater
outdoors!
Doing so may
result in
electric shock!
•
Risk of
electric shock
!
DO NOT OPEN!
No user-serviceable parts inside!
•
NEVER modify this heater
. Doing so could result in personal
injury
or property
damage.
Modification of this fireplace
completely voids all warranties
.
•
ALWAYS
turn this heater off before unplugging it from the outlet.
•
ALWAYS
disconnect
this unit from the
power
supply
before
performing any assembly or
cleaning, or before relocating the electric fireplace.
•
NEVER
leave this heater unattended.
ALWAYS
unplug this heater when not in use.
•
ALWAYS
store this heater in a dry location.
NEVER
use the fireplace if it has become wet.A
•
ONLY
use this heater on a
120V AC 15-Amp circuit
.
NEVER
overload the circuit.
If this
heater trips the circuit breaker, unplug all other appliances on the same circuit before the
next use. Avoid plugging other appliances into the same circuit as this heater.
•
NEVER
plug this heater into an outlet that is
old
,
cracked
, or has any
loose wires or
connections
. Plugging this heater into a faulty outlet could result in
electric
arcing
within
the outlet that could cause the
outlet
to
overheat or catch
fire
.
•
ALWAYS
check your heater cord and plug connections with
each use
!
1.
MAKE SURE
the plug fits tight in the outlet! Faulty wall outlet connections or
loose plugs can cause the outlet to overheat.
2.
Heaters draw more current
than small appliances.
Overheating
may occur even
if it has not occurred with the use of other appliances.
3. During use
check frequently
to see if the
plug outlet or faceplate
is
HOT
! If the
outlet or faceplate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.
This heater has a polarized plug (one blade is wider than the other). As a safety feature to
reduce the risk of electrical shock, this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to defeat this safety feature.