Pill Reminder Device User Manual

Page 2 - 6 ITW Dynatec c. 1999
Revised 12/99 TPC-2 TIMER Manual #50-05
Installing the TPC-2 and Accessories
1. Mount the TPC-2 Control Unit as close to the Trigger Input Device and the Glue
Applicators as is possible.
2. Mount the Trigger Device and Glue Applicator(s) in the desired locations. Connect the
Drive Output Cable(s) to the Glue Applicator(s).
3. Install the Automatic Tip Sealer(s) to the Glue Applicator(s) (cold glue systems) and
connect the Drive Output Cable(s) to the Automatic Tip Sealer(s).
4. Connect all cables to their proper receptacles on the bottom of the TPC-2 Control Unit.
There is a legend along the bottom of the Display Panel (inside the Control Unit lid)
indicating the input/output connector assigments.
5. Install Sealing Caps (106116 and/or 106023) to unused receptacles if IP54 integrity is
required in the following manner:
a. Remove the 2 screws that secure the lower portion of the TPC-2 Control Unit
display panel using a cross-point screwdriver.
b. Remove the lower panel (the portion housing the power switch and fuse holder)
from the case taking care not to strain the wires connected to the backside of the
panel. This will allow access to the nuts attaching the receptacle flanges to the
Control Unit Case.
c. Remove one of the screws attaching each unused receptacle flange and place
the screw through the eyelet of the appropriate Sealing Cap tether (106116 is used
for the 4-pin and 106023 is used for the 9-pin receptacle).
d. Reverse Steps (a) through (c) taking care not to pinch any wires in the process.
6. Connect the TPC-2 Control Unit power cord to a clean, properly grounded power
source of the appropriate voltage (115 or 230VAC). Observe wiring, grounding and
safety practices in accord with all local electrical codes. The 115VAC version of the
TPC-2 comes with a standard 10-amp plug on the end of the cord. The 230VAC version
of the TPC-2 has no plug. Instead, bare wires are provided for connection into a terminal
box. The wires should be connected as follows: