Operation Manual

Setting the
alarm mode
socket). Never use cleaning agents as they could damage
the housing.
Insert the plug into a mains socket (make sure the mains voltage
matches that of the device).
Switch on the radio by moving the function switch  into the ON
position.
Set the band selector switch to the required position (VHF or
MW) . Set the volume using the volume control .
Set the radio to the VHF or medium wave frequency of your
choice using the tuner .
FM (VHF): Unwind and position the wire aerial for best
reception of VHF.
AM /MW: The radio has a sensitive ferrite aerial.
Press and hold down the TIME button  (TIME / TIME-SET)
whilst pressing the HOURS  or MINUTES  button until you
see the correct time in the display.
Press the ALARM  and HOURS  or MINUTES  button until
the required alarm time appears in the display.
1 First set the required alarm time as explained above.
2 If you wish to be woken by the buzzer set the FUNCTION
SWITCH  to BUZZ (ALARM). The activated alarm mode is
then shown in the display.
· If you wish to be woken by the radio, set the FUNCTION
13
Connecting
to mains
Radio
reception
Aerials
Setting
the time
Setting the
alarm time
Gb
Manual_alle Sprachen 20.10.2003 15:01 Uhr Seite 13