Installation Guide

Bottom Ladder Hardware

1. Mark a line on the bottom of each side rail 1½” in from the front edge

(figure 16)

2. Line up the Bottom Wheel Housing to the line drawn on the bottom of the side rail of

the ladder using the “U” bracket portion of the housing. Verify that the bracket is flush

with the bottom of the ladder. Because of the 12-degree angle of the bottom of the

ladder this will align the housing diagonally across the ladder side rail

(figure 17)

3. Using a ⅛” drill bit, predrill the hole for the Philips-drive pan-head ¾” long screw and

secure the Bottom Wheel Housing to the inside of the ladder side rail

(see below)

4. Using a ¼” drill bit and the top

fastener hole in the Bottom Wheel

Housing as a guide, drill a through

hole in the ladder side rail

(figure 18).

5. Use the nut cap/threaded rod and

the acorn nut to fasten the top of the

Bottom Wheel Housing to the ladder

side rail (using a 4 mm Allen wrench

and a 10 mm open end wrench)

(

see the three images below)

Figure 16 Figure 17

Figure 18

1½”