Specifications

31
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
LIGHT BULB REPLACEMENT
To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry
tissue or paper towel to handle the glass portion of the bulb.
Headlight
To prevent bulb from inadvertantly disconnecting and possibly melting or igniting plastic components, the
locking ring MUST be reinstalled after installation of replacement bulb.
Pull the locking ring straight off the back of the light hous-
ing and allow it to slide down the harness and out of the
way.
Rotate bulb socket a quarter turn counterclockwise to
unlock. Pull out bulb and socket. Insert new bulb and rotate
socket a quarter turn clockwise to secure.
Slide locking ring over new bulb socket and onto back of
light housing.
Turn Signal
Locate the turn signal bulb socket on backside of light
housing. Rotate a quarter turn counterclockwise to unlock
and remove from housing. Insert replacement bulb and
rotate a quarter turn clockwise to secure in place.
Brake Light
Remove two phillips head screws securing lens and pull
lens out of housing to access the brake light bulb. Remove
the light bulb and install a new bulb, making sure bulb
makes good contact with socket. Replace the lens and
reinstall the phillips head screws.
FUSE REPLACEMENT
To replace fuses, raise the seat bottom, the fuse block is located on the
fender liner on the driver side of the vehicle. Pull out old fuse and replace
with a new fuse of the same type and size.
Turn Signal
Bulb
Headlight
Bulb
Rear Fender
Lens
Bulb
Fuse Block