User manual

Page 43
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
PSI 9000 DT Series
3.4 Manual operation
3.4.1 Switching on the device
The device should, as far as possible, always be switched on using the toggle switch on the front of the device.
Afterswitchingon,thedisplaywillrstshowthecompanylogo,followedbyalanguageselectionwhichwillclose
automatically after 3 seconds and later manufacturer’s name and address,devicetype,rmwareversion(s),serial
number and item number.
In setup (see section „3.4.3. Conguration via MENU“), in the second level menu “General settings” is an option
“Output after power ON” in which the user can determine the condition of the DC output after power-up. Factory
setting here is “OFF”, meaning that the DC output on power-up is always switched off. “Restore” means that the
last condition of the DC output will be restored, either on or off. All set values are always saved and restored.
3.4.2 Switching off the device
On switch-off the last output condition and the most recent set values are saved. Furthermore, a PF alarm (power
failure) will be reported, but can be ignored.
The DC output is immediately switched off and after a short while fans will shut down and after another few seconds
the device will be completely powered off.
3.4.3 Conguration via MENU
TheMENUservestocongurealloperatingparameterswhich
arenotconstantlyrequired.Thesecanbesetbyngertouchon
the MENU touch area, but only if the DC output is switched OFF.
Seeguretotheright.
If the DC output is switched on the settings menu will not be shown,
only status information.
Menunavigationisbyngertouch.Valuesaresetusingtherotary
knobs. The assignments of the rotary knobs, if multiple values
can be set in a particular menu, is not always depicted. Following
rule for such situations: upper value -> left knob, lower value .>
right knob.

The menu structure is shown schematically on the following pages.
Some setting parameters are self-explanatory, others are not. The
latter will be explained on the pages following.