User manual

Page 48
PSI 9000 DT Series
www.elektroautomatik.de
[e-mail]
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
3.4.3.2 Menu “User Events”
See „3.6.2.1 User dened events“ on page 60.
3.4.3.3 Menu “Proles”
See „3.8 Loading and saving a user prole“ on page 62.
3.4.3.4 Menu “Overview”
This menu page displays an overview of the set values (U, I, P or U, I, P, R) and alarm settings as well as settings
limits. These can only be displayed, not changed.
3.4.3.5 Menu “About HW, SW...”
This menu page displays an overview of device relevant data such as serial number, article number etc., as well as
an alarm history which lists the number of device alarms that probably occurred since the device has been powered.
3.4.3.6 Menu “Function Generator”
See „3.9 The function generator“ on page 63.
3.4.3.7 Menu “Communication”
HeresettingsfortheEthernetportarecongured.TheUSBporttheredoesn’trequireanysettings.
After deliverey or a complete reset, the Ethernet port has following default settings assigned:
• DHCP: off
• IP: 192.168.0.2
• Subnet mask: 255.255.255.0
• Gateway: 192.168.0.1
• Port: 5025
• DNS: 0.0.0.0
• Hostname:empty,butcongurableviaHMI
• Domain:empty,butcongurableviaHMI
Thosesettingscanbechangedanytimeandconguredtomeetlocalrequirements.Furthermore,thereareglobal
communication settings available regarding timing and protocols.
Submenu “Ethernet -> IP Settings”
Element Description
DHCP With setting DHCP the device will instantly try to get network parameters (IP, subnet mask, gateway,
DNS) assigned from a DHCP server after power-on or when changing from Manual to DHCP and
submittingthechangewithbuttonENTER.IftheDHCPcongurationattemptfails,thedevicewill
use the settings from Manual. In this case, the overview in screen View settings will indicate the
DCHP status as DHCP (failed), otherwise as DHCP(active)
Manual Manual (default setting): uses either the default network parameters (after reset) or the last user
setting. Those parameters are not overwritten by selection DHCP and are thus available again
when switching to Manual again.
IP address Only available with setting “Manual”. Default value: 192.168.0.2
Permanent manual setting of the device’s IP address in standard IP format
Subnet mask Only available with setting “Manual”. Default value: 255.255.255.0
Permanent manual setting of the subnet mask in standard IP format
Gateway Only available with setting “Manual”. Default value: 192.168.0.1
Permanent manual setting of the gateway address in standard IP format
Port Default value: 5025
Adjust the socket port here, which belongs to the IP adress and serves for TCP/P access when
controlling the device remotely via Ethernet
DNS address Default value: 0.0.0.0
Permanent manual setting of the network address of a domain name server (short: DNS) which
has to be present in order to translate the host name to the device’s IP, so the device could
alternatively access by the host name