Operating instructions

14
T
ro
u
b
lesh
o
ot
i
ng
?
?
Problem
Cause
Action Required
The paint runs on
the item being
sprayed
Paint is thin or
irregular
No paint being
produced
Paint too diluted
Paint volume too high
Moving too slowly
Gun trigger held too long
Gun too close
Paint too diluted
Paint volume too low
Moving too fast
Spray gun clogged
Spray gun too far away
Paint too thick
Gun clogged
Paint feed tube clogged
Air hose split
Grainy paint
Container almost empty
Gun at an angle
Air intake blocked
Add undiluted material
Reduce the paint flow by turning
Fluid Adjusting Screw (8) clockwise
Increase speed of application
Release trigger earlier
Increase the distance between gun
and work-piece
Add undiluted material
Increase the paint flow by turning Fluid
Adjusting Screw (8) anticlockwise
Reduce speed of application
Clean the spray gun
Reduce the distance between spray
gun and work-piece
Add water
Clean the spray gun
Clean Paint Feed Tube (11)
Replace Air Hose (19)
Filter the paint
Refill Paint Container (13)
Ensure Paint Feed Tube (11) is
collecting paint
Check no paper or loose debris can
block the air intake
Paint too thick
Gun clogged
Paint feed tube clogged
Add water
Clean the spray gun
Clean Paint Feed Tube (11)
Paint being
sprayed gives an
orange peel effect