Operating instructions

9
To obtain the best results always keep your spray gun level and at an equal distance from
the object you are spraying, idealy 10”-12” (side to side or up or down) from the surface.
Avoid spraying at an angle as this will lead to runs on the surface (Fig.4a-4c).
Let your arm control the left to right movement rather than your wrist as this will help give
you an even paint distribution over the whole area.
Do not tip the spray gun to more than a 45˚ angle when the motor is switched OFF. You can
tip the spray gun at more of an angle when spraying provided the motor is switched ON.
1.
2.
3.
l The volume of paint sprayed is easily adjustable (Fig.3).
l Completely close the Fluid Adjusting Screw (8) by turning fully
clockwise. While pulling the Trigger (14), begin turning the fluid
adjusting screw anticlockwise until the volume of paint you require is
obtained.
l If the paint spray is too wide or contains too much paint turn the Fluid
Adjusting Screw (8) clockwise again. Once the correct spray pattern is
obtained you are able to commence spraying. The paint volume needs
to be adjusted everytime you change the spray pattern, especially when
you use the round pattern, as this can often contain too much paint.
P
a
i
nt
V
o
lu
m
e
Spraying Technique
F
ig
.
3
Fig.4a
Fig.4b
Fig.4c
M
in.