Product Manual A

THIS SIDE UP WHEN NOT IN USE
WARNING
DO NOT START ENGINE IF FUEL IS SPILLED. WIPE OFF
EXCESS FUEL AND ALLOW TO DRY. REMOVE ENGINE
FROM AREA TO AVOID SPARKS.
NEVER RUN ENGINE INDOORS. EXHAUST FUMES ARE
DEADLY.
DO NOT ATTEMPT TO START ENGINE IN THE FOL
LOWING WAYS:
• DO NOT USE STARTING FLUID
• DO NOT SPRAY FLAMMABLE LIQUIDS OR VAPORS
INTO AIR CLEANER, CARBURETOR, OR SPARK
PLUG CHAMBER.
• DO NOT REMOVE SPARK PLUG AND ATTEMPT TO
START ENGINE. FLAMMABLE FUEL CAN SPRAY
OUT AND IGNITE FROM A SPARK FROM SPARK
PLUG.
WARNING
IF AUGER IS MOUNTED TO ENGINE, ALL SAFETY
GUARDS MUST BE SECURELY ON TO AVOID SERIOUS
INJURY.
NEVER LEAVE ENGINE RUNNING WHILE UNATTENDED.
TURN OFF AFTER EVERY USE.
TO STOP ENGINE
1. Flip the ON/OFF switch to the OFF position.
2. (For Briggs & Stratton and Honda Engine) close fuel shut-
o valve.
MAINTENANCE AND STORAGE
STEPS FOR WORKING ON EQUIPMENT
1. Turn engine switch to the OFF position.
2. Disconnect the spark plug wire from the spark plug.
3. Securely place the disconnected spark plug wire away
from the spark plug and any metal parts. This must
always be done or arcing may occur between spark plug
wire and metal parts.
4. Replace or repair the part on the powerhead.
5. Check all parts that were repaired, or removed during
repair, that they are secure and t correctly.
NOTE: All repair parts must come from the manufacturer.
NEVER replace parts that are not specically designed
for the powerhead.
6. Reconnect the spark plug wire.
POWERHEAD MAINTENANCE
1. Keep all screws, nuts, and bolts tight.
2. If auger performance decreases, carefully inspect cutter
edge of blade for any signs of wear. If the blades show
any of these signs, they need to be replaced.
3. Always allow muer to cool before lling fuel tank.
4. DO NOT ll fuel tank indoors or when engine is running
or is hot.
ENGINE MAINTENANCE
Please read your engine manual, included with the unit, and
observe its recommendations to extend the life of your engine.
Your engine manual provides detailed information about your
engine and a maintenance schedule.
TRANSPORTING YOUR UNIT
1. NEVER transport powerhead inside an enclosed space
or vehicle. Fuel or fuel vapors may ignite causing serious
injury or death.
2. If fuel is present in the fuel tank, transport in an open
vehicle in an upright position.
3. If an enclosed vehicle must be used, remove fuel in an
approved red fuel container.
4. Run engine to use up the fuel in the carburetor and fuel
tank. Always run engine in a well ventilated area.
5. Wipe away any spilled fuel from powerhead and earth
auger. Allow to dry prior to transport.
6. When transporting your powerhead, make sure you
position the unit according to the "This Side Up When
Not In Use" decal.
10
Operator's Manual
Two-Man Earth Auger Powerhead 9800 Series
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5