Warranty Guide

 Please refer back to Job Site Preparation.
 If below grade, you must lay a 6-mil Polyfilm with seams overlapping 8" (200 mm) in addition to 2-
in-1 underlayment.
 Fasten Polyfilm seams every 18" to 24"(450 to 600 mm) with duct tape or poly tape.
 Run 4" (100 mm) of poly-film up against the perimeter of wall.
 Lay foam underlayment by butting edges and then duct tape the full length of the seam.
Floating Installation Step by Step:
 The sub-floor should be free from any surface
defect. If it is not, fill gaps with leveling material
designed for your subfloor type.
 Cut out imperfections in plank or place them in
less visible areas.
 Lay out a layer of 6 mil Polyfilm and a layer of
foam underlayment OR 2-in-1 foam
underlayment.
 Run 4” of the Polyfilm up against the perimeter
walls.
 Use chalk line to trace starting line with ½”
expansion joint at the side and ¼” at row ends.
 Place expansion spacer every 12” along all walls
to prevent movement during installation.
 Open several carton of floor planks and lay out
4 to 5 rows of planks ahead of time. Choose
planks so that they match in terms of
woodgrains and color of your choice.
 Install 1
st
plank along the starting line with the
tongue facing out.