Product Manual

Cold Water Gas • Rev. 12/05/2017

CHEMICAL APPLICATION

Downstream Chemical Injection: Standard on direct drive units, optional on others. High

Pressure Soap is an optional feature.

NOTE: Do not remove back flow preventer as chemical may flow back into potable water

source. For standard chemical injection, ensure the black nozzle is properly fitted at the

end of the wand. The chemical injector will not function if this nozzle is not fitted.

1. Chemical preparation – Select detergent/chemical that best suits your cleaning task. Prepare

dilution according to the manufacturer’s instructions. The volume of chemical being used may be

adjusted at valve located on the chemical injector. Note: for EK Pumps, the volume is preset and

cannot be adjusted.

2. Insert the intake hose, located on the chemical injector at the pump, into the chemical being

used.

3. Fit black nozzle on the standard wand, or for the dual wand, turn adjustment knob on, and

adjust for required flow rate. For high pressure soap systems, the black nozzle is not needed; use

one of the other wand nozzles.

4. To apply chemical, engage trigger on pressure wand assembly. Turn chemical injector’s nipple

to adjust flow. For the high pressure soap systems, open ball valve and engage trigger.

5. Chemical can now be applied through pressure wand assembly. It will take 5 – 15 seconds for

chemical to travel to spray nozzle. The volume of chemical being used may be adjusted at the

chemical injector.

6. For best results apply chemical from bottom to top, and allow for proper penetration time prior

to rinsing. Do not allow chemical to dry. Rinse from bottom to top and then top to bottom.

WINTER PUMP PROTECTION

The following procedure MUST be used when the pressure washing unit is stored at

temperatures below freezing.

1. All water must be drained or blown (via compressed air) from system. Connect a short piece

of male fitted ½” garden type hose on to the water inlet on the pump assembly.

2. Place the open end of the hose into a wide mouthed container of full strength, winter rated,

vehicle windshield washing fluid or Anti-Freeze, RATED FOR MINIMUM -40°C.

3. Connect the pressure wand assembly.