Operation Manual

Loading the Batteries

This camera uses 2 AAA batteries.

1. Slide the battery cover in the direction of the arrow, then lift to open.

2. Load the included batteries into the battery compartment. (a)

Insert SD card

Insert the SD card into the slot. (b)

NOTE: 1. Do not open the battery compartment while the USB file

transfer is in process.

2. Once new batteries are loaded, users will need to reset the date

and time.

3. Do not open the battery cover or remove the batteries when the

camera is in its “ON” status. Only remove the batteries when

the camera is not in use, or in its “OFF” status.

4. If you do not plan on using the camera for a long period of

time, please remove the batteries.

5. This camera, built in a memory, is ready for use without a SD

memory card.

CAUTION! 1. It is recommended that rechargeable batteries be used.

2. To improve battery performance, replace all installed batteries

at the same time and keep batteries away from heat

3. Do not mix battery types or it may cause a fire or explosion.

Use only one battery type at one time.

4. Batteries should be inserted in the battery compartment with the

“+” and “-” sides facing correctly.