Operation Manual

24
the subject.
The images are not
stored
Before storing the
images, the camera
turned itself off.
If the Low power
message appears,
replace the batteries at
once.
The pictures cannot be
stored onto a computer
through a USB cable
The driver program is
not installed.
Incorrect installation.
1. Before connecting the
USB cable, install the
driver and power on the
camera.
2. Remove the driver
and related programs
and then reinstall them
in accordance with the
User’s Guide.
The pictures can not be
viewed on a TV screen
The data cable is not
connected properly.
The TV end of cable is
not plugged in properly
Use an AV cable to
connect with the TV.
Set the PAL/NTSC
mode properly.
The camera can not be
used as a PC camera
head.
The camera is not set as
a video camera head
Set the camera as a
video camera head
The camera is down or
does not operate
properly.
The flash has been used
continuously.
High humidity
The camera has been
used near a magnetic
field
Take out the batteries to
power off the camera
completely. Power on it
again after 10 seconds.