Manual

5 Technical data
Order code INSTAT 868-a1S
EDP No. 0536 37 141 …
Operating voltage 230 V~ (195 to 253 V) 50 Hz
Switching current: 10 mA…10 A heating load
10 mA… 4 A motor load
Power consumption ~0,73 W
Operating temperature 0 to +40 °C
Storage temperature –20 to +60 °C
Transmition frequency 868,95 Mhz
Antenna internal
Lamps 1
Button to learn
Software class A
Pollution degree 2
Rated impulse voltage 4 KV
Ball pressure test
temperature 75 ± 2 °C
Voltage and Current for
the for purposes of
interfernce measurements 250 V / 0,1 A
Degree of protection IP 20 insulated
(condensation not allowed)
Class of protection I
Weight ~ 210 g
Table 2: If the device does not function, check the following:
Check Yes No
1 Is mains voltage available? continue with 2 check fuse
if necessary, consult an electrician
2 Directly plug the heater into the wall outlet heater functions! heater or connecting cable defective
continue with 3
3 Receiver:
Does the signal light ash? Transmitter signal missing. continue with 4
Is the signal tone emitted? continue with 4 see 4.4
(if necessary, wait for an hour)
4 Transmitter: Is the battery OK? continue with 5 insert new batteries.
continue with 5
5 Transmitter: set to 30°C. continue with 6 device was already switched on
Does the device switch on after continue with 6 or if transmitter signal is missing,
approx. 30 s continue with 7
6 Transmitter: set to 5°C. function OK transmitter signal is missing, continue with 7
Does the device switch o after approx 30 s
7 Re-learn the connection to the receiver. function OK continue with 8
Repeat Sections 5 or 6 and check if it if applicable, check transmission range
works now. refer to 3.1 “Testing the transmission range”
8 Reduce distance between transmitter transmitter and receiver transmitter or receiver defective
and receiver to approx. 2m. work properly.
Repeat Sections 5 or 6 and check if it
works now.
6 Quick reference
Section Description
Testing the transmission range 3.1 • Set 30° and 5° continuously on the transmitter
• Receiver switches ON and OFF
• If the receiver does not change over any more,
the range is exceeded
Establish wireless connection 4.1 • set transmitter to Learning mode
At the receiver:
• Press button briey, short signal tone, lamp is blinking
• if transmitter is recognized, lamp is switched OFF
Delete radio link 4.2 • Hold down button for 5 sec., short signal tone, lamp is blinking
• Signal tone and lamp switched o shows success setting
Cancel • don‘t press button for 30 sec or
• press button as long as lamp is switched OFF
Signal lamp/signal tone: 4.4 see Table 1 Section 4.4.2
Dimensions
71,3
41,9
77,5
71,3
This unit can be used in all EU and EFTA countries.
The manufacturer herewith declares that the device com-
plies with the basic requirements and all other relevant
regulations of the RED (2014/53/EU) directive.
The declaration of conformity can be downloaded from
„www.funk868MHz.de“.
t
*
This product should not be disposed of with household waste. Please recy-
cle the products where facilities for electronic waste exist. Check with your
local authorities for recycling advice.