Installation Guide

Clutch (Chain) Operated Roller Shades Installation Guide

Getting Started

Parts Included: Unpack your shade and identify the following parts required for installation.

Step 1-Mount the Brackets

Set of brackets

Safety tension device

(attached to chain)

(4) Screws

for brackets

❶ On inside of window frame, mark the right side

bracket location with a pencil and mount the

brackets using two screws.

❷ Repeat for the bracket on the other side.

*Note: Screws provided are

for installation into wooden

frame or studs only. For other

surfaces such as wallboard,

plaster, metal, or concrete,

please purchase the appropri-

ate screws and hardware.

Clutch end

Pin end

(2) Screws

for tension

device

(2) Plastic

stop balls

*Tools Needed: Flat head screwdriver, Phillips screwdriver, Drill (optional), Pencil, Tape Measure

The clutch (chain) end of the shade is positioned on the

right side. The pin end is positioned on the left side.

INSIDE

OUTSIDE

The shade can be mounted either inside the window frame or outside

the window frame or wall. The brackets are universal—there are no

“right” or “left” brackets.

INSIDE MOUNT

❶ ❷

Page 1

PAGE 1
Clutch (Chain) Operated Roller Shades Installation Guide Getting Started Parts Included: Unpack your shade and identify the following parts required for installation. *Note: Screws provided are for installation into wooden frame or studs only. For other surfaces such as wallboard, plaster, metal, or concrete, please purchase the appropriate screws and hardware.
PAGE 2
Clutch (Chain) Operated Roller Shades Installation Guide OUTSIDE MOUNT ❶ Mark the location for the clutch side (right side) bracket with a pencil and mount the bracket using two screws. ❷ Insert the shade into the mounted bracket by sliding the hooks into the slots. ❸ Fit the pin-end bracket onto the round spring pin-end plug (left side) while making sure shade is level. Press the bracket in at least 1/8” for necessary pressure on the pin. ❹ Mark the bracket location and remove shade.
PAGE 3
Clutch (Chain) Operated Roller Shades Installation Guide Test the Shade Roll the shade up and down several times. If the fabric shifts on the roller noticeably to either side, you can correct the problem as follows: Fabric shifts toward the left: Lower the shade fully until the aluminum roller tube is exposed. Place a small piece of tape (masking tape works well) approximately 1 1/2” long near the right edge of the roller (see illustration). Test the shade and add additional layers of tape as needed.