Product Manual

36
PLEASE NOTE: 20H IS FOR OUTDOOR PERMANENT INSTALLATIONS ONLY AND 20HI IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL
AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.
Phone: [phone] | Email: [e-mail] | Address: 315 - A Industrial RD Summerville, SC 29483
English
Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
POWER CORD:
• The electric power supply requirement for this water heater is 120 VAC/60HZ, 2 Amps.
• The water heater comes with a three (3) pin power supply cord. Use only a power outletv with a
ground terminal.
• The installation of an electric leakage breaker is recommended. (GFCI)
• Keep any excess of the power supply cord on the outside of the water heater.
• If local codes require hardwiring, see instructions for “Hardwiring the Electrical Connections”.
WARNING: Shock hazard line voltage is
present. Before servicing the water heater, turn
o the electrical power to the water heater at
the main disconnect or circuit breaker. Failure to
do so could result in severe personal injury or
death.
CAUTION: Label all wires prior to
disconnection when servicing controls. Wiring
errors can cause improper and dangerous
operation. Verify correct operation after
servicing.
Electric Wiring Diagram
20HI Installation
Electrical Connections
English-20Liter-Series-ManualV4_OK.indd 36 3/12/2019 10:55:04 PM