Product Manual

10
Product Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
FILLING THE WATER HEATER
CAUTION!: Before powering the water heater, be sure that the
system is completely filled with water and All AIR IS REMOVED. If Water pipes
Before connecting the power, fill the tank and system with water and
check for leaks. To be sure that all air is out of the water system, open
the hot water faucets on your fixtures until constant water flows. Any air
remaining in the tank will cause the water heater element to fail.
filling the water heater:
1. Open the hot water faucet.
2. Open the cold water supply valve.
3. When continuous water flows out of the faucet, the tank is filled.
4. Close the hot water faucet.
5. Check entire system for leaks.
ELECTRICAL CONNECTIONS
To be certain that all of the air is out of the water heater, open the HOT
water faucet on your fixtures until constant water flows from them. If air
remains in the tank, the element will be damaged when the electric cord
is plugged in.
Connect the water heater to a GROUNDED OUTLET.
The water heater is fitted with a power cord that is intended to
plug into a grounded 110-120 V/AC receptacle. Adhere to all
pertinent State and local codes. Install the correct size circuit
breaker into the master panel. The Seisco EMT water heater was
manufactured and wired in accordance with UL requirements.
The water heater is equipped with an overheat limiting device
with a manual reset. Also known as the temperature high limit,
this device has been factory installed to interrupt the power
supply in the event of a thermostat failure.
THIS WATER HEATER IS DESIGNED FOR 110-120V
SERVICE - DO NOT CONNECT TO ANY OTHER VOLTAGE.
Failure to use proper voltage may result in personal injury and/or
property damage. If the supplied electrical power cord is either damaged
or not long enough, do NOT use an extension cord. Have a licensed
electrician replace the power cord.