User's Manual

104 Controlling a Street Lighting Network
7. In the Value box, perform one of the following tasks:
• Select the preset to be used to update the values of all the data points
added to the Scheduler that have that preset defined for them.
Alternatively, you can enter a new preset and then go back to the
Scheduler: Data Points Web page and define the value (or values) for
the preset.
• Enter a valid value to be written to all the data points. To enter a
value, all the data points added to the Scheduler must have the same
network variable type (for example, SNVT_switch).
8. In the Priority box, enter a priority for the event between 0 to 255
(highest to lowest priority). This priority essentially locks out events
with lower priorities so that they cannot update the data points written
to by this event. After the Scheduler executes the event, the data points
can only be updated by an event that has an equal or higher priority.
9. To create additional events in the exception, right-click anywhere in the
Time or Value boxes, and select Add from the shortcut menu. A new row
for the event is added to the dialog. Repeat steps 4–7 to specify the Time
and Value of the new event in the exception. You can create up to one
event per minute.