User's Manual

126 Interoperable Interface for the Street Light Bridge
Variable Description Modifiable?
nciPriRpt Defines the repeat count for the
primary path.
Yes
See
Defining the Networking
Channels
on page 36 for
information about defining
channels.
nciSecChs Defines channels for RF data
transmission on the secondary
(alternate) LonTalk (ISO/IEC
14908-1) path.
Valid values are 11 to 26. Values
outside this range are ignored.
Yes
See
Defining the Networking
Channels
on page 36 for
information about defining
channels.
Use 0 (zero) to indicate an unused
channel.
nciSecRpt Contains the repeat count used for
the secondary path.
Yes
See
Defining the Networking
Channels
on page 36 for
information about defining
channels.
nciRepeatMode Defines the Street Light Bridge
repeating type:
0 – normal repeating operation
(PL and RF)
1 – PL-PL repeating (no RF
transmission)
2 – RF-RF repeating (no PL
transmission)
Yes
See
Defining Repeating on page 40
for information about setting the
repeat mode.
nciMediaAccess Defines the power line media
access protocol:
0 – Default (media access protocol
is enabled during manufacturing,
based on the module model type)
1 – Normal (overrides firmware
setting and defines a PL-20N
channel)
2 – CENELEC (overrides firmware
setting and defines a PL-20C
channel)
Yes
See
Defining the Media Access
Protocol
on page 37 for information
about setting the media access
protocol.
Changes to this value take effect
only after a device resets.