User's Manual

Street Light Bridge Integrator’s Guide 51
Installing Devices
After enabling smart network management for all the applicable device
properties, click Submit. The SmartServer performs the following tasks for each
device that you are installing:
1. Fetches the program ID of the device (if the Smart Network Management
checkbox is selected for the Program ID property).
2. Downloads the application image file to the device (if the Smart Network
Management checkbox is selected for the Application Image property).
The SmartServer downloads the application image file that has a
program ID matching that of the device application; the application
image file must be in the /LonWorks/Import folder.
3. Loads and instantiates the device interface (if the Smart Network
Management checkbox is selected for the Template property):
a. The SmartServer first attempts to load the device template (.XML
file) that has a matching program ID; the device template must be in
the /config/template/lonworks folder on the flash disk.
b. If the SmartServer cannot find a matching device template, the
SmartServer loads the device interface (XIF) file that has a matching
program ID; the XIF file must be in the /LonWorks/Import folder.
c. The SmartServer creates all the functional blocks and data points
defined by the device interface.
4. Re-commissions the device. Commissioning downloads network
configuration data and application configuration data to the device.
5. Writes configuration property default values defined in the XIF file to the
device.
6. Resets the device, which starts the device application.
7. Sets the device application online.
Checking Device Installation Status
You can use the LON Command Queue Web page to check the status of the
management commands you have submitted for one or more devices:
1. Right-click the local SmartServer icon, select Setup, and select LON
Command Queue from the shortcut menu. Alternatively, you can click
the Tools icon and select LON Command Queue.