User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance
- RF Statements
- Introduction
- Installation for the Street Lighting Solution
- Setting Up the Segment Controller
- Planning for the Street Lighting Solution
- Managing a Street Lighting Network
- Controlling a Street Lighting Network
- Interoperable Interface for the Street Light Bridge
- Cryptography License
- Glossary
Street Light Bridge Integrator’s Guide 53
4. You can right-click the header, a table entry, or an empty space in the
application frame and select one of the following options from the
shortcut menu:
Clear Table
Clears all entries in the LON Command Queue table. The table
automatically re-lists pending commands (STATUS_REQUEST)
and updates their statuses after the commands successfully
complete or fail.
Configure
Device
Opens the Driver or General properties page for the selected
device.
Cancel
Command
Cancels the selected command and deletes it from the table. You
can select multiple commands by clicking one, holding down
CTRL, and clicking the other commands to cancel. You can also
use this option to delete inactive commands from the table.
Troubleshooting Street Lighting Network
Installation
If a device is not installed by the SmartServer even after the entire network
installation has been completed, it is likely that the device has failed or the
SmartServer cannot reach it through a repeating device. In this case, you can do
the following:
1. Add another device (such as a Street Light Bridge module) at an
intermediate spot on the network that will serve only as a repeater. See
Adding Devices
on page 64 for more information about adding devices to
an installed power line repeating network.
2. Replace the device to determine if it has failed. See
Replacing Devices
on
page
67 for more information about replacing devices on a power line
repeating network.
Maintaining a Street Lighting Network
You can perform routine maintenance to update, repair, and optimize an
installed street lighting network. You can use the SmartServer to maintain the
network and its devices. For example, if a device fails, you can replace it on the
physical network and then logically replace it on the SmartServer, preserving the
device’s configuration.
This section describes the following network maintenance tasks that you can
perform with the SmartServer:
• Analyze the power line repeating network using the Power Line
Repeating Analysis Web page
• Adding devices
• Upgrade devices
• Replace devices
• Decommission devices