User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance
- RF Statements
- Introduction
- Installation for the Street Lighting Solution
- Setting Up the Segment Controller
- Planning for the Street Lighting Solution
- Managing a Street Lighting Network
- Controlling a Street Lighting Network
- Interoperable Interface for the Street Light Bridge
- Cryptography License
- Glossary
Street Light Bridge Integrator’s Guide 57
a. The proxy in the repeating chain that directly communicates with
the SmartServer is listed in the Direct Communication column.
b. The next proxy in the repeating chain, which does not have direct
communication with the SmartServer, is listed in the Proxy Zone
1 column.
c. The proxy that can directly communicate with the target device
(the proxy agent) is listed in the Proxy Zone 2 column.
d. The target device is listed in the Proxy Zone 3 column.
If a target device requires the maximum of eight hops, you can scroll to
the right to Proxy Zone 7 column to view the target device and its
repeating chain to the left.
4. You can display statistics related to the power line signal at the hop
between a device and its proxy by selecting the following checkboxes at
the top of the Web page (you can view all the statistics by clicking the
Display All Standard Information checkbox).
Last Time
Reached
The time at which the device last responded to a network
message.
Frequency in use
The frequency carrier of the signal at the hop (Primary or
Secondary). For more information on the use of these frequency
carriers on a L
ONWORKS power line channel, see the
LonWorks
PLT-22 Power Line Transceiver User’s Guide (110kHz - 140kHz
Operation)
.