User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance
- RF Statements
- Introduction
- Installation for the Street Lighting Solution
- Setting Up the Segment Controller
- Planning for the Street Lighting Solution
- Managing a Street Lighting Network
- Controlling a Street Lighting Network
- Interoperable Interface for the Street Light Bridge
- Cryptography License
- Glossary
Street Light Bridge Integrator’s Guide 67
then select the Smart Network Management checkbox to the left of the
Application Image property in the device Web page and click Submit.
7. Activate the XIF files for the devices (if necessary): Right-click one of the
selected devices in the SmartServer tree, select Manage, and click
Activate Template in the shortcut menu. Alternatively, you can clear and
then select the Smart Network Management checkbox to the left of the
Template property in the device Web page and click Submit.
8. To check the status of the device upgrade, open the LON Command
Queue Web page: Right-click the SmartServer icon, select Setup, and
select LON Command Queue from the shortcut menu. Alternatively, you
can open the Tools menu and click LON Command Queue. See
Checking
Device Installation Status
on page 51 for more information about using
this Web page.
Replacing Devices
You can use the SmartServer to replace a device if the device fails or a newer
version of the device becomes available. Note the following requirements when
replacing a device:
• The replacement device must have the same program ID as the original
device.
• The application image file and device interface should match the original
device; otherwise, you might have to upgrade the replacement device as
well.