User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance
- RF Statements
- Introduction
- Installation for the Street Lighting Solution
- Setting Up the Segment Controller
- Planning for the Street Lighting Solution
- Managing a Street Lighting Network
- Controlling a Street Lighting Network
- Interoperable Interface for the Street Light Bridge
- Cryptography License
- Glossary
72 Managing a Street Lighting Network
Alternatively, you can change the Application Status property to
Application Stopped (Offline) in the from the Setup tab of the device Web
page, which appears when you select devices in step 1.
3. The SmartServer places the devices in the soft offline state (the device
has an application loaded and is configured, but it is offline). The offline
devices are highlighted red in the SmartServer tree and in the Power
Line Repeating Analysis Web page.
4. To place a device back online, select one or more devices to set online,
right-click a selected device, select Manage, and select Set Online.
Alternatively, you can select the Smart Network Management checkbox
for the Application Status property from the Setup tab of the device Web
page and then click Submit, or you can change the Application Status
property to Application Running (Online) and click Submit.
Testing Devices
You can use the SmartServer to query the status of a device and to wink a device.
You can query the status of a device to ensure that it is operating and that it is
configured correctly. Querying a device opens a dialog that lists network traffic
statistics that you can use to evaluate the performance of the device. Winking a
device enables you to identify the device on the network and verify that it is
communicating properly.