User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance
- RF Statements
- Introduction
- Installation for the Street Lighting Solution
- Setting Up the Segment Controller
- Planning for the Street Lighting Solution
- Managing a Street Lighting Network
- Controlling a Street Lighting Network
- Interoperable Interface for the Street Light Bridge
- Cryptography License
- Glossary
82 Controlling a Street Lighting Network
Manually Configuring the Time
You can manually configure the SmartServer’s real-time clock:
1. Right-click the SmartServer icon, select Setup, and select Time from the
shortcut menu.
Alternatively, you can click Tools and then select Time to configure the
time settings on the local SmartServer.
2. The Setup Time Web page opens.
3. In the Timezone property, select the time zone in which the SmartServer is
located.
4. In the Date and Local Time property, enter the time and date to be stored in
the SmartServer's real time clock. You might need to refresh the Web page
to view the current time.
5. Click Submit to save the changes.
Note that if the Last Sync Time property does not show a valid timestamp for the
SNTP server’s most recent synchronization (for example, if it shows “Unknown”),
it is likely that the configuration for the SNTP server is incorrect. Check that the
server name is correct and that port 123 is available.
Entering the Location of the SmartServer
You can enter the geographic coordinates of the SmartServer: