Instructions / Assembly

6 English
ASSEMBLY
Unpacking
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-877-396-3036 for assistance.
Packing List
String Trimmer
Front Handle with Hardware
0.080 in. Replacement Line
Bolts (2)
Nuts (2)
Hex Key
Safety Glasses
Operator’s Manual
WARNING
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the product when assembling parts.
Assembling the Tool
See Figure 2.
 Remove bolts and nuts from the hardware bag.
 Align the connector on the upper end of the tool with the
connector on the lower end of the tool.
 Slide the connectors together and, using the hex key
provided, secure with bolts and nuts. Tighten securely.
NOTE: Orient the nuts so that they sit in the recessed
areas on the connectors.
WARNING
Failure to properly assemble the tool as describe above
could result in the tool separating and cause serious
personal injury.
CAUTION
Be careful when sliding the two ends together to avoid
pinching your hands or fingers.
WARNING
This string trimmer is not capable of using other
attachments or cutting heads. Attempting to use other
attachments or cutting heads could result in serious
personal injury.
Attaching the Front Handle
See Figure 3.
 Remove the bolts, flat washers, and lock washers from
the front handle.
 Install the handle between the arrow and the connector
on the upper end of the tool.
NOTE: When properly installed, the front handle will angle
toward the operator.
 Adjust handle up or down, if necessary, to desired
operating position.
NOTE: The front handle should always be placed beyond
the arrow. This is the minimum acceptable distance
between the front and rear handle.
 Reinstall the washers and bolts; tighten securely.