Instruction v.11 Owner manual

Instruction Sheet
Instructions
SUBJECT: FENDERS AND TAIL
LIGHTS KIT # 77510-00
FITS MODELS: LS21, LS22 & LS27
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
Figure 1
Figure 2
Figure 4
Figure 5
Figure 3
PN 77199-00
Rev. 100114
INSTALL FENDERS AND LIGHTS
1. Route the tail light connector end of the harness to the
back of the machine by putting it through the frame at
location shown in Figure 1.
2. Attach the fenders and light bracket to the machine
with three 5/16 x 1" hex head bolts, three 5/16" fender
washers on the inside of the fender, three 5/16" nylock
flange nuts on the outside of the fender. See Figure 4
for details. There will also need to be coated clamps
mounted at the rear hole locations of each fender for
wire harness routing purposes.
3. It is important to route the harness through the
clamps before securing them in place at the rear hole
location.
NEVER exceed 45 mph while towing this log
splitter