Instruction v.2 Owner's manual

Instruction Sheet
Instructions
PN 77379-00
Rev. 050112
SUBJECT: CAST WEDGE KIT,
Part # 77380-00
FITS MODELS:
ALL LOG SPLITTERS
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables (if applicable) and make sure all moving
parts have come to a complete stop.
WARNING
INSTALLATION
Remove the existing wedge.1.
Using the provided 1/2 x 4" carriage bolt (1), 2.
washer and centerlock nut to secure the new
cast wedge (2) to cylinder. Make sure the
new wedge is pressed against the cylinder
attachment point as firmly as possible before
applying full torque to nut and carriage bolt.
Place the six 1/2 x 2" carriage bolts (3) into 3.
holes of cast wedge base. Working one side at
a time, stack the wedge spacer (4) and bottom
wedge plate (5) and place onto three carriage
bolts securing them in place with 1/2" centerlock
nuts. Repeat for other side of wedge.
For log splitters serial number C01076 and VIN 4.
5VJAA001XBW003132 below, the addition of
the shims (6) will be necessary when mounting
the spacers (4) and bottom plates (5) to wedge.
See illustration for mounting details.
CAST WEDGE KIT, PN 77380-00
PART # DESCRIPTION QTY.
15049 NUT, 1/2 CENTERLOCK GR8 ZP 7
15339 BOLT, 1/2 X 2 CRG 6
15762-00 WASHER, 1/2 GR8 SAE FLAT 1
15895-00 BOLT, 1/2 X 4 GR8 CRG 1
32232-12 WEDGE, CAST LOG SPLITTER 1
77376-12 SPACER, WEDGE 2
77377-12 PLATE, BOTTOM WEDGE 2
77378-12 SHIM, SPACER 2
1
2
3
4
5
6