Instruction v.2 User guide

Instruction Sheet

Instructions

PN 76267-00

Rev. 121608

SUBJECT: LOG SPLITTER

SUPPORT KIT #76273-00

FITS MODELS: LS27270, LS27270T,

LS21160, LS21160T, LS21170,

LS21170T, LS33340, LS33340T,

LS21E

SN: 810430 AND BELOW

VIN: 5VJAA00168W001572 AND BELOW

Before inspecting or servicing any part of this machine,

shut off power source, remove key, disconnect the

battery cables and make sure all moving parts have

come to a complete stop.

WARNING

These instructions will describe how to install a support for the log splitter.

DRILL TWO HOLES IN LOG SPLITTER BASE

1. Drill two holes in the log splitter base that are .34" in diameter. The dimensions from the edges are shown below.

1.20"

1.15"

.75"

PAGE 1
Instructions WARNING SUBJECT: LOG SPLITTER SUPPORT KIT #76273-00 FITS MODELS: LS27270, LS27270T, LS21160, LS21160T, LS21170, LS21170T, LS33340, LS33340T, LS21E Before inspecting or servicing any part of this machine, shut off power source, remove key, disconnect the battery cables and make sure all moving parts have come to a complete stop. SN: 810430 AND BELOW VIN: 5VJAA00168W001572 AND BELOW These instructions will describe how to install a support for the log splitter.
PAGE 2
INSTALLATION 1. Bolt the leg support base underneath the log splitter with two (2) 5/6 x 1" bolts and nuts as shown. 2. Bolt the nylon lanyard to the support base with the 1/4 x 3/4" hex head bolt, 1/4" washer, and 1/4" nut. 7 3. Attach the support leg to the support base with the snapper pin and adjust as necessary. 4. Secure the snapper pin with the nylon lanyard. operation 3 8 1 • Use the support base to keep the log splitter from tipping over while splitting logs.