Installation guide

114548 Page3
Why install a DishPro Quad LNBF
The DishPro Quad LNBF allows you to receive signals from
the 110
o
West and 119
o
West satellites, and route these
signals directly to as many as four receiver tuners.
Note:SomeDISH
®
Network receivers have one tuner, and
some have two. The DishPro Quad LNBF can be used with
any combination of receivers where the total number of
tuners does not exceed four. To support more than four
receiver tuners, you will need to add one or more DishPro
switches (see Diagram 2 on page 11).
Important: The DishPro Quad LNBF should be used only
with systems that have all DishPro switches, LNBFs and
receivers. These can be recognized by the DishPro logo
shown below.
If you have LNBFs, switches or receivers in your system that
do not have the DishPro logo, you cannot use the DishPro
Quad LNBF in your system. The one exception is that you
can use the DishPro Quad LNBF with a non-DishPro receiver
if the receiver is equipped with a DishPro Adapter. For
information on DishPro Adapters, call your local
114548_DP_Quad_Instructions.fm Page 3 Friday, May 31, 2002 1:35 PM