Installation guide

Page 4 114548
DISH Network dealer or the DISH Network at 800-333-
DISH (3474).
Installing the DishPro Quad LNBF in an
Existing System
If you are installing the DishPro Quad LNBF in an existing
DishPro system where the dish has already been pointed for
the strongest possible signal, follow the directions below. If
you are installing the DishPro Quad LNBF as part of a new
DISH 500 installation, follow the instructions that begin on
page 7. To install the DishPro Quad LNBF in an
existing system:
1. Remove the existing LNBF from your satellite dish and
disconnect the existing coaxial cables.
2. Connect coaxial cables from the DishPro Quad LNBF on
the DISH 500 to your receivers or to a DishPro switch.
Note: If there are no switches in your system, you can
connect the cable directly from any of the four ports on
the DishPro Quad LNBF to a receiver tuner. If there is a
DishPro Switch in your system, make sure you connect
LNBF ports 1 and 2 or ports 3 and 4 to any input
114548_DP_Quad_Instructions.fm Page 4 Friday, May 31, 2002 1:35 PM