Installation guide

114548 Page5
connections on the DishPro switch (see diagram, below).
Thetworemainingportscanbeusedtosendthesignalto
another switch, to other receiver tuners, or left
disconnected.
3. Turn on a DishPro receiver connected to the system. Go
to the Point Dish/Signal menu. With most receivers, you
can do this by pressing Menu on the remote and selecting
System Setup, Installation, then Point Dish/
Signal.
4. When the Point Dish/Signal menu opens, select
Check Switch and then Check to run Check Switch.
Port 3
Port 2
Port 1
114548_DP_Quad_Instructions.fm Page 5 Friday, May 31, 2002 1:35 PM