Installation guide

Page 6 114548
5. When the Check Switch procedure finishes, you should
see a summary screen similar to the one shown below for
receivers direct connected to the DishPro Quad LNBF.
Note: Your installation summary screen may look
different from the one shown here depending on your
installation. For example, you may see “Twin” on the line
next to “Device” instead of “Quad.” This is okay and
does not indicate a problem. What is important is that
you see a signal from both satellites, and the message
“Satellite reception verified.”
6. Run check switch on all other receivers in your system by
repeating steps #3, #4 and #5 on each receiver.
114548_DP_Quad_Instructions.fm Page 6 Friday, May 31, 2002 1:35 PM