Installation guide

114548 Page7
Installing the DishPro Quad LNBF in a
New DISH 500 System
If you are installing the DishPro Quad LNBF in a new
system, follow the instructions that came with your DishPro
receiver for installing a DishPro DISH 500 System, except
install the DishPro Quad LNBF in place of the DishPro Twin
LNBF. You can also get these instructions from our web site,
www.dishnetwork.com.
Note: If the DishPro Quad LNBF is not detected when you
run check switch, it may be that your receiver requires a
software upgrade. To get this upgrade, do the following:
1. Make sure the Quad LNBF is connected directly to the
receiver with no multi-dish switches between the LNBF
and the receiver.
2. Open the Point Dish/Signal menu and make sure the
number under Transponder is an odd number higher
than 10, for example, 11, 13 or 15. If it is not, move the
highlight to the box under Transponder and use the Up
or Down arrow to change the number to an odd number
higher than 10. Also make sure there is a check mark
next to 119 W.
3. Point your DISH 500 for the strongest possible signal
from the 119 West satellite.
114548_DP_Quad_Instructions.fm Page 7 Friday, May 31, 2002 1:35 PM