Installation guide

Page 8 114548
4. Select Check Switch then Check.
5. When Check Switch completes, you will see a message
asking if the mounting and positioning of your dish is
complete with a “Locked” indication in the Point Dish/
Signal screen.If the answer is “yes,” select Yes.
6. The receiver will begin taking a software upgrade.
7. When the upgrade completes, you will need to run
Check Switch again to detect the DishPro Quad LNBF
and to confirm signals from both satellites.
Pointing the DISH 500 for the strongest possible signal
using a signal strength meter (squawker box).
If you are you using a signal strength meter or audible
peaking device to fine-tune the aim of a satellite dish
withtheDishProQuadLNBF,makesureyoufirst
connect the coaxial cable from the peaking device to Port
1oftheLNBF(shownonthefollowingpage)topeakon
119 W. This will make sure you are pointing the dish for
the strongest possible signal from the 119 West satellite.
Then move the coaxial cable to Port 2 and point the dish
for the strongest signal from the 110 West satellite. After
you’ve done this, follow the instructions on page 4 titled
114548_DP_Quad_Instructions.fm Page 8 Friday, May 31, 2002 1:35 PM