Instruction manual


DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. Most of
the water will be evaporated by the coil for maximum efficiency. However in very warm
temperature or humid condition, excessive condensation may occur and will require water
drainage when tank is full. If the tank is full,
both of the compressor and motor will stop. The
“water full” sign will light ON, also the machine will beep as reminder.
To make the cooling work again, please empty the water by one of the following ways:
1.
Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water
to drain out.
4. When the container is almost full,
replace the rubber plug in the drain
hole and empty the water tray.
5.
Repeat until the unit is emptied.
6. Replace the rubber plug and tighten
the drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should
not be flashing.
FIG.19
If you wish to operate the unit without the need to empty the water tank, please:
• Remove the drain knob and
rubber plug and retain for future
use.
• Connect the drain tube supplied
to the water outlet as shown and
locate the other end into a drain.
FIG.20
- 13 -