Technical data
P
P
SAFETY PRECAUTIONS
•
A lack of air flow can lead
S
Infants, children, elderly people,
. This will cause the unit
to overheating and fire.
and people not senstive to
deterioration due to
humidity.
chemicals and solvents
dissolved in the air.
•
Do not clean unit when
power is on as it may cause
fire and electric shock, it may
cause an injury.
•
There is danger of fire or
electric shock.
•
You may be injured if you
fall or if the unit falls over.
•
Operation without filters
may cause failure.
•
It may cause failure of
appliance or accident.
•
Water may spill inside th
unit, causing insulation
failure and electrical
shock or fire.
Do not, underany
circumstances, cut,
remove, or bypass
the earth lead.
This unit isgrounded through the
power cord plug when plugged
into a matching wall outlet.
Fig.1
Electrical Information
•
The manufacture's nameplate is located on the rear panel of
the unit and contains electrical and other technical data
specific to this unit.
•
The dehumidifier must be properly earthed. To minimize
shock and fire hazards, proper earthing is important. The
power cord is equipped with a three-pin plug for
protection against shock hazards.
•
Your dehumidifier must be used in a properly grounded wall
receptacle. If the wall receptacle you intend to use is not
adequately grounded or protected by a time delay fuse or
circuit breaker, have a qualified electrician install the proper
receptacle.
•
Ensure the receptacle is accessible after the unit installation.
•
Do not use extension cords or an adapter plugs with this
unit.
However, if it is necessary to use an extension cord, use
a sufficiently rated extension and ensure cord is fully
unwound to avoid heat build-up.
•
To avoid the possibility of personal injury, always disconnect
the power supply to the unit, before installing and/or servicing.