Technical data

P 
P
OPERATING THE UNIT
Using the unit
• When first using the dehumidifier, operate the unit continuously 24 hours.
• This unit is designed to operate with a working environment between 5
° C and 35 ° C.
• If the unit has been switched off and needs to be switched on again quickly, allow approximately
three minutes for the correct operation to resume.
• Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other electrical appliances.
• Select a suitable location, making sure you have easy access to an electrical outlet.
• Plug the unit into a 11 5V- 60HzJ220-240V 50Hz(Refer to the nameplate located on the side/rear of the unit ) electrical
socket-outlet with earth connection.
• Make sure the bucket is correctly fitted otherwise the unit will not operate properly.
Emptying the water tank
1. Pull out the bucket a little.
There are two ways to remove collected water.
1. Use the bucket
• When the bucket is full, the unit will automatically stop
running, and the Full indicator light will illuminate.
• Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does
not spill. Do not put the bucket on the floor because the
bottom of the bucket is uneven. Otherwise the bucket will
fall and cause the water to spill.
• Throw away the water and replace the bucket. The bucket
must be in place and securely seated for the dehumidifier
2. Hold both sides of the bucket
to operate. 
with even strength, and pull it
• The machine will re-start when the bucket is restored 
out from the unit.
in its correct position.
NOTES:
• When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
• Be sure to push the bucket gently all the way into the unit.
Banging the bucket against anything or failing to push it in 
0
securely may cause the unit not to operate.
3. Pour the water out.
0
L  P