User manual

TO DRAIN WATER (Continuous Drainage)
You may use a hose with an inner diameter of 12mm for
continuous drainage:
1. Use a screwdriver to remove the knockout at the back
Attach the hose to the connector through the hole.
2. The hose must lead to an appropriate drain at a downward
slope with no sharp bends.
TO EMPTY THE TANK
1. When the tank is full, the "FULL" LED light will illuminate and the unit will stop.
2. Do not move the unit or remove the tank , if the machine is still operating, as
water may leak, damage the unit or cause an electric shock.
3. To remove the
tank , pull it out gently by gripping the bottom of the tank , one hand
on the left and lift carefully. (Turn off for 5 minutes before empty the tank.)
NOTE :
Clean the tank with clean water if needed. Do not use detergent, solvent, abrasive
or hot water to avoid damage to the appliance.
Do not remove or damage the float in the tank , the unit will not
work correctly.
The "FULL" LED light will stay on until the tank is restore to the correct position.
Knockout
Hose
Note:
1. Ensure the tank is well fitted in position before inserting the hose.
2. Before removing the tank, ensure that the hose is disconnected
.
4. Remove the side cover on top of the tank before pouring water.
5. Pour the water by the left-front end of the tank, clean the tank and restore the tank to the
correct position.
Pulling Out Lifting Remove Cover
Pouring water Restore Cover Restore Tank
9