CA Cleaning Products Right to Know Act

5
ENGLISH
3. When using the vac to pick up fine dust, it will be
necessary to empty the dust tank and clean or
replace the filter at more frequent intervals to
maintain peak vac performance.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the hose. Twist slightly to tighten the connection.
7. Plug the cord into the wall outlet. The vacuum is
ready for use.
8. Turn the unit “ON” by pushing the switch from
position “O” to position “I”. The “O” is the
“OFF” position and the “I” is the “ON” position.
NOTICE:
A dry filter is necessary to pick up dry material. If
use the vac to pick up dust when the filter is wet,
the filter will clog quickly and be very difficult to
clean. If the filter gets wet, replace it before
continuing to do dry pickups.
REMEMBER! The foam filter and reusable dry filter
with ring must be installed for dry pick up.
1. when vacuuming liquid, remove the reusable
filter and any disposable dust bag (not include).
For foam wet filter installation instruction,
see INSTALLING THE FOAM FILTER.
2. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
3. Insert the hose end into inlet of tank.
4. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the hose. Twist slightly to tighten the connection.
5. Plug the cord into the wall outlet. The vacuum is
ready for use.
6. Turn the unit “ON” by pushing the switch from
position “O” to position “I”. The “O” is the “OFF”
position and the “I” is the “ON” position.
WET PICK-UP
This wet/dry vac is equipped with a float
mechanism which will rise automatically to cut
o
ff the airflow when the liquid in the tank reaches
a predetermined level. When this happens, turn off
vac, unplug the power cord, and empty the dust
tank. You will know that the float has shut the
airflow off because the suction ceases and the
motor noise becomes higher in pitch due to
increased motor speed. The liquid capacity may
vary with the rate of pickup.
NOTICE:
WET PICK-UP ACCESSORIES SHOULD BE WASHED
PERIODICALLY, ESPECIALLY AFTER PICKING UP
WET, STICKY FLUIDS OR SPILLS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF
SOAP AND WATER.