User guide

ManualsBrandsECOXGEAR ManualsAcousticsECOXPRO

Waterproof Speaker Case (Model: GDI-EGPRO100/101/102/103/104/105/106/107/108/109/110)

Specifications

Frequency Range: 160Hz-20,000Hz Output Power: 3 Watt

Power Source: 3 x AA-size batteries Battery Life: 30 + hours with alkaline batteries

Dimensions: 7.3” (L) x 4.7” (W) x 2.6” (H) Headset Jack: Waterproof 3.5mm headset jack

Weight: 1.06lb Floating payload (MP3 player, keys, documents etc) maximum: 8 ounces

Temperature (Operating): 23°F to 104°F IPX7 Waterproof Rating: water submersion not to exceed 3’ depth for 30 minutes

Temperature (Storage): 14°F to 131°F

FCC Compliance Statement & Warning: This device has been tested & found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The device generates, uses & can radiate radio

frequency energy & if not installed & used in accordance with instructions may cause harmful interference to radio communications. There is no guarantee that interference will

not occur in a particular installation IF this device causes interference to radio or television reception try one of these measures: reorient or relocate the receiving antenna,

Increase separation between device & receiver, connect the device into an outlet on a circuit different from that to which the receiver is connected, consult a dealer or

experienced radio / TV technician for assistance. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the device and/or void the manufacturer’s limited warranty.

INTRODUCTION Thank you for your purchase of the ECOXPRO speaker case by ECOXGEAR. The ECOXPRO is a waterproof case with

a built-in amplified waterproof external speaker & waterproof 3.5mm earphone jack. The case will hold & protect your MP3 player, cell phone,

keys & other personal items from the elements.

Location of Controls

1) Power / Volume Knob: To optimize your speaker’s sound set your audio device’s volume (e.g. iPod, cell phone, MP3 player, etc.) to

approximately 75% of the maximum level. Rotate the ECOXPRO’s volume knob to the right to increase volume. To turn the unit ‘off’, turn

the knob to the left until a ‘click’ is felt & the LED above the volume knob turns ‘off’.

2) Power LED: The LED above the volume knob illuminates ‘on’ when the batteries are in use, even if you do not hear sound from the

speaker or connected headset. To optimize the lifespan of the batteries turn the ECOXPRO off when not listening to music.

Installing Batteries

1) Open the ECOXPRO & remove the battery door. The battery door is located on the inside

compartment of the ECOXPRO.

2) Insert (3) AA batteries in the battery compartment. Be sure the ‘+’ and ‘-‘ of the batteries

are inserted in the same orientation per the picture & markings shown to the right.

IMPORTANT: Use new, fully charged & commonly branded batteries. Improper batteries

may result in audio distortion or “hum” from the speaker

3) Replace the battery door.

Listening to your Music

1) Plug the ECOXPRO audio cable into the headset jack of your audio

device / source (e.g. MP3 player, iPod, iPhone, Smartphone, etc.)

2) BEFORE connecting your Smartphone device, use the SELECTOR

to set between 2 categories (I or S) of device connectors:

“ I ” includes: iPhone & iPod, HTC, Motorola, BlackBerry, LG, Palm

“ S ” includes: Samsung, Sony Ericsson, Nokia

NOTE: The slide switch is for selecting the ECOXPRO’s audio interface circuit to work best with either

of the two major classes of smartphones / audio devices. The iPhone position is for smartphones made

by Apple (iPhones and iPods), Blackberry, HTC, LG, Motorola and Palm. The Samsung position is

for those made by Samsung and Sony Ericsson, Nokia and other manufacturers.

3) Turn the volume on your audio source up to a normal listening level and choose ‘play’.

NOTE: for best sound turn the source volume up to approximately 75% of the maximum level. If the

volume on your audio source is too low, the volume level out of ECOXPRO speaker or headset may be

too low. If the volume level on your audio source is at 100%, the speaker audio may distort due to

excessive high volume level output.

4) Turn the volume on the ECOXPRO to the desired listening level over the speaker or connected

headset.

ECOXPRO

I: iPhone, HTC, Motorola,

Blackberry, LG, Palm

S: Samsung,

Sony Ericsson, Nokia

Selector

Waterproof 3.5mm Headset Jack

Summary of content (3 pages)

PAGE 1
ECOXPRO Waterproof Speaker Case (Model: GDI-EGPRO100/101/102/103/104/105/106/107/108/109/110) Specifications Frequency Range: 160Hz-20,000Hz Power Source: 3 x AA-size batteries Dimensions: 7.3” (L) x 4.7” (W) x 2.6” (H) Weight: 1.06lb Temperature (Operating): 23°F to 104°F Temperature (Storage): 14°F to 131°F Output Power: 3 Watt Battery Life: 30 + hours with alkaline batteries Headset Jack: Waterproof 3.
PAGE 2
Care, Maintenance & Precautions 1. 2. Although the product is waterproof, it is NOT designed for use under water. Do NOT intentionally submerge the unit underwater. Close both safety latches properly before use, as shown in ‘figure 2a’ below. If the unit is placed in water without the latches properly closed, water may enter into the battery compartment and void your warranty. Safety Lock Switch 3. 4. 5. 6. 7. 8. 9. 2c 2b 2a Dry the unit completely before opening.
PAGE 3
Attention: Selector Switch (Smartphone Type Selector) I: iPhone, HTC, Motorola, Blackberry, LG, Palm I S S: Samsung, Sony Ericsson, Nokia Selector “ I ” includes iPhone & iPod, HTC, Motorola, BlackBerry, LG, Palm. “ S ” includes Samsung, Sony Ericsson, Nokia. Before connecting your Smartphone device, use the SELECTOR to set I or S for your device, respectively. For details, please refer to user guide. HEADSET JACK use external 3.