Installation & Assembly

Installation Instructions for

Verne Chandelier

1.0

EC10912

Chandelier

EC10912

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant junction

boxes.

This product is safety listed for damp locations.

Incandescent lamps may be dimmed with a standard incandescent dimmer.

LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer

for additional information.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the hazards

involved.

Use minimum 90°c supply conductors.

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

SAVETHESE INSTRUCTIONS!

PAGE 1
EC10912 Installation Instructions for Verne Chandelier EC10912 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Chandelier Use minimum 90°c supply conductors. GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations.
PAGE 2
Install the Fixture 1A JUNCTION BOX 9 8 MOUNTING PLATE HALF BALL CANOPY 1 COLLAR NUT STEM HALF BALL ASSEMBLY 12 SHADE STEM ASSEMBLY 11 4 LAMP SHADE BASE COLUMN SHADE 3 1 2 Screw the half ball to the stem which will be on top. 3 Feed the fixture wires through the column, then screw it onto the fixture. 4 5 Feed the fixture wires through the stem assembly, then screw it onto the column.